Click here to donate to keep PhreeqcUsers open
Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email
?
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
Forum Home
Login
Register
PhreeqcUsers Discussion Forum
»
Beginners
»
PHREEQC basics
»
Sequence of PHREEQC calculations
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: Sequence of PHREEQC calculations (Read 266 times)
MichaelZ20
Top Contributor
Posts: 90
Sequence of PHREEQC calculations
«
on:
November 11, 2021, 09:03:21 PM »
Hi, David!
I have not found a place of SOLID_SOLUTION calculations in the sequence of calculations described in the manual. Where is it?
Logged
dlparkhurst
Top Contributor
Posts: 2583
Re: Sequence of PHREEQC calculations
«
Reply #1 on:
November 11, 2021, 10:07:31 PM »
For non-ideal binary solid solutions, there is a calculation to determine the critical temperature, spinodal gap, miscibility gap, etc. This calculation occurs occurs just after reading END that includes the SOLID_SOLUTION data block. The calculation does not involve interaction with a solution. The results are printed in a section of output labeled "Description of Solid Solution xxx". There is no calculation or output for an ideal solid solution.
The same code is called whenever the temperature changes, although there is no printout. Think of it as an extra temperature-dependent calculation like calculating log Ks for the phases.
There is no other SOLID_SOLUTION-specific calculation. Basically, a solid solution in SOLID_SOLUTION is used in the same way as a phase in EQUILIBRIUM_PHASES. When included, the solid solution reacts to equilibrium with the solution or dissolves entirely.
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
PhreeqcUsers Discussion Forum
»
Beginners
»
PHREEQC basics
»
Sequence of PHREEQC calculations