Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email
?
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
Forum Home
Login
Register
PhreeqcUsers Discussion Forum
»
Beginners
»
PHREEQC Basics
»
SOLUTION and amount of cells
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: SOLUTION and amount of cells (Read 671 times)
Max1
Frequent Contributor
Posts: 19
SOLUTION and amount of cells
«
on:
September 16, 2015, 01:56:56 PM »
Hi all,
I have a question concerning your SOLUTION input and the amount of cells you define. I was under the impression that the every number in your SOLUTION accounts for 1 cell, e.g when defining SOLUTION 1-10, you have the cells 1-10 that contain this solution. However, your amount of cells apparently doesn't need to match it. If you define 7.5 cells in TRANSPORT, I'm not sure how your solution gets divided over these cells. Do these 7.5 cells have the SOLUTION defined in 1-10? And what happens to the solution 7.5-10?
Thanks in advance.
Logged
dlparkhurst
Top Contributor
Posts: 1130
Re: SOLUTION and amount of cells
«
Reply #1 on:
September 16, 2015, 04:28:51 PM »
The cells in your column is defined by TRANSPORT; -cells n, where n is an integer (not 7.5). SOLUTIONS 1 through n must be defined either individually or all together as SOLUTION 1-10. If the number of cells in TRANSPORT is less than 10, say 7. Then solutions 8, 9, and 10 are defined, but not used in the transport simulation.
Fine points. If flow is -backward, then solution n+1 flows into the column at cell n. If stagnant cells are used, then solutions n+2 and greater will be part of the flow system.
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
PhreeqcUsers Discussion Forum
»
Beginners
»
PHREEQC Basics
»
SOLUTION and amount of cells